1424483383056.jpg

Preventative Maintenance

WE SAVE YOU MONEY $$ AND REWARD YOU with DISCOUNTS FOR DOING ROUTINE MAINTENANCE

Our preventative seasonal maintenance plan is tiered to fit your budget needs, take care of your HVAC system, and it will take care of you during the process.

Maintenance is generally scheduled to maintain peak efficiency, help keep utility bills lower, extend the life of your HVAC system, and avert failures. The cliché “out of sight, out of mind” is often the reason for neglected maintenance on your HVAC system(s). HVAC system(s) are usually installed where they aren’t seen, such as in a section of the basement, a closet, on rooftops, behind/side the of the house, or in mechanical rooms, making them easy to ignore. The systems are simply taken for granted, until they fail. Decreased efficiency, utility over-payment, discomfort, loss of productivity, premature replacement, and higher repair costs are the result. 

ONE TIME HVAC INSPECTION

  • 5% Discount on repairs

  • Check refrigerant levels

  • ONE TIME Annual INSPECTION (1 system) starting at $159

  • Each additional system $49

  • Clear drain line(s)

  • Visual inspection of return filters

  • inspection of indoor & outdoor units

  • Recommendations for system tune-ups *as needed 

  • Inspection of duct work

  • check refrigerant charge

  • Inspect heat exchanger / heat strips

  • Inspect electrical connections

  • Inspect burners

SUPERIOR MAINTENANCE PLAN

  • 20% Discount on repairs

  • Check refrigerant levels

  • semi-Annual maintenance (1 system) starting at $229

  • Each additional system $59

  • Clear drain line(s) and add drain solution to drain lines.

  • Test motors

  • Test capacitors under load

  • Rinse down the outdoor condensing coil

  • Clean debris from the outdoor condensing unit

  • Clean and de-grease condensing unit and housing

  • Replace batteries in the thermostat

  • Replace customer-provided filters

  • Clean burners

  • Inspect heat exchanger

  • Clean flame sensor

  • Inspection of ductwork

  • Inspection of all safety and limit switches

  • Inspect ignition system and safety controls—clean and adjust as needed

  • Measure temperature rise and adjust airflow as needed

  • Check vent system for proper operation

  • Check combustion blower housing for lint and debris and clean as necessary